美森:冷藏容器的先驱

Matson has a long history with refrigerated container shipping in the Pacific. 其冷藏货物的创新处理始于1900年,其不断改进的精神导致其成为航运业中最好的冷藏集装箱系统之一. Careful consideration of customers’ needs resulted in the following standard features:

  • 温度控制在1度以内
    Precise control for transporting extremely temperature-sensitive cargo such as pharmaceuticals
  • Availability of Modified Atmospheres to limit cargo respiration rate
    Reduces or eliminates the presence of carbon dioxide, 氮, and /or oxygen to reduce or eliminate spoilage from interaction with these gases; single insertion of atmosphere at time of loading; most effective for short-duration voyages
  • The use of substitute atmospheres for Controlled Atmosphere applications
    Further retards ripening by maintaining a substitute atmosphere for the duration of the voyage
  • The most advanced sealing techniques are used to construct and test our refrigerated containers
    美森的冷冻箱在运输过程中最大限度地减少大气损失,而控制大气系统在运输过程中保持选定的大气,直到集装箱被打开
  • 特殊设计,最大限度减少皮重
    Content weight can be maximized on inland transportation
  • Length and height choices to accommodate a variety of needs
    几个集装箱的长度和两个高度提供了一个总载货能力的选择,这取决于货物的类型和所需的包装密度
  • Motor- generators for inland shipping where no other power is available
    温度 control continues during Port to Door inland transportation
  • 远程冷藏监控
    On-board operators can check refrigerated container conditions using an on-board PC:

    • 温度
    • 行动需要提醒
    • 上传单位温度的长期历史

这些功能的设计都是为了提供最高水平的冷藏产品质量和完整性, 以及运输过程中的最大载荷, whether ocean transit or inland trucking to the final destination.


温度控制backtop

现代冷藏集装箱结合最大容量和气流与精确的温度控制,在整个负载提供均匀的保护. Matson的设备可以将温度控制在初始温度设定的一定程度内(这是制药运输的关键要求), 例如). 还有“双区”单元,可以在同一个容器中进行两种不同程度的冷却.


大气中修改backtop

美森拥有专门建造和装备的改装大气(MA)和控制大气(CA)应用容器. 该设备在容器的前部设有端口,以便于特定大气气体的高效流动进入容器,同时迫使氧气和其他现有气体出来.

修改后的大气(MA)

All refrigerated products require protection from heat, 冷或某些气体, 包括氧气, to impede deterioration of the goods and chemical reactions with gases. 应托运人的要求, 美森可以安排几家领先的技术公司在米乐m6的原产地港口的集装箱内提供改性大气.

控制大气(CA)

更长的运输时间, 在整个过程中,控制气氛保持一个恒定的水平,以减缓自然成熟过程. 这使得农产品可以在接近船期的时候装进集装箱,从而使农产品在田间成熟的时间更长, 使它们在目的地的价值更高. Controlled Atmosphere是另一种由领先技术公司提供的产品,将被插入米乐m6在原产地港特别设计的集装箱中.

了解更多有关米乐m6的 大气改造服务提供商程序 奥克兰和长滩的人.


概述-温控容器 backtop

美森提供40英尺和20英尺的冷藏集装箱,以满足米乐m6米乐m6app官网下载横跨米乐m6app官网下载航运的需求. 该设备能够处理冷藏和冷冻货物横跨米乐m6app官网下载,以保护货物的完整性和质量.

除了米乐m6庞大的集装箱库存, 美森有一个大的, diversified chassis inventory to meet customer needs (excluding 那霸 and 中国 services). 底盘设计包括标准固定底盘, 专用滑轴底盘, 和专门的三轴底盘. The latter two designs increase the weight that may be transported over roads.

See the specific refrigerated container sizes below for each service.


冷藏电源和发电机组backtop

大多数马森冷冻机是双电压的, 从而节约了分离成本, dual-voltage transformers mounted at the shipper’s facility.

While our equipment is in transit between the port and the customer’s facility, 这取决于商品和旅行的距离, power for the reefers can be provided by Matson’s chassis-mounted, under-slung, diesel-powered generators which provide 220 / 440-volt, three-phase electric power when away from a normal power source. 发电机增加了集装箱和底盘的重量,这额外的重量必须考虑到集装箱的装载,以符合超过道路重量限制.


前阶段评审backtop

美森所有的设备在收到米乐m6app官网下载的设备后都经过了一个清洗和校准的过程. 这个过程, 也被称为预旅行, 在每次货物移动之后,在设备离开码头装载新货物之前完成. 校准是一个过程,需要检查设备,以确定其处于良好的工作状态. When this process is completed, the unit is set at a standard temperature of 35 degrees.


温度设置 & 电机发电操作说明backtop

发电机组启动指令

Before start-up, both the Genset Circuit Breaker (CB1) and the refrigerated unit should be OFF. 启动后, 机组运行至少2分钟,使电源稳定后,再向制冷机组供电. 这将消除任何潜在的冷启动瞬态峰值到达制冷单元. 冷启动瞬态峰值可能会在对电峰值或瞬态敏感的制冷装置上引起令人讨厌的过电压警报.

警告

  • Beware of moving poly V-belt, belt-driven components, and hot exhaust components.
  • 在任何情况下都不能将乙醚或任何未经授权的起动辅助装置与进气加热器一起使用.

请注意

Piston rings in engines that have operated less than 100 hours may not be fully seated. This may lead to the possibility of oil seepage from the exhaust pipe. To properly seat the rings, operate the engine under full load for a period of 24 hours. If the condition persists, check valve clearance when the engine is cold.

标准单位使用说明

  • Make sure that Circuit Breaker CB-1 is in the OFF position.
  • Hook up the 460-volt cable from the refrigerated unit to the Genset receptacle.
  • Hold the Intake Heater Switch (HS) in the PREHEAT position. Suggested hold times for a cold engine are as follows:
环境温度 Time
26°C (78°F) 5秒
0到26°C(32到78°F) 10秒
-8至26°C(18至32°F) 20秒
下面8°C(8°F) 30秒
  • With the Intake Heater Switch (HS) held in the PREHEAT position, place the Ignition Switch (IGN) in the START position.
  • 在发动机启动后, 继续保持进气加热开关(HS)在预热位置,直到发动机产生足够的油压以关闭油压安全开关(约5秒)。. 被释放后, 进气加热器开关(HS)会自动回到OFF位置,加热器保持通电3分钟.

使用自动启动的单位说明

  • Make sure that Circuit Breaker CB-1 is in the OFF position.
  • Hook up the 460-volt cable from the refrigerated unit to the Genset receptacle.
  • 将点火开关(IGN)置于运行位置.
  • If the Low Coolant Sensor (LCS) is immersed in coolant, the 米乐m6 Restart Module will energize the heater for 30秒 and the safety buzzer will sound. After the 30 second delay, the unit will attempt to start.

后起动检查

  • Allow the Genset unit to run for at least 2 minutes.
  • 闭合断路器CB-1.
  • 用电压表检查发电机输出, voltage output at startup with no load at 50Hz operation should be 1500 RPM, 360 - 460年休假. Voltage output may vary and fall with ISO specifications based on ambient.
  • 启动制冷装置.
  • Run the engine for 10 minutes (check total time meter operation).
  • 监听轴承异常噪音(交流发电机).
  • Check the fuel lines, lube oil lines, and filters for leaks.
  • 检查排气系统是否有泄漏.

停止指令

  • 将断路器CB-1置于OFF位置.
  • 将点火开关(IGN)置于OFF位置.

 

冷藏的指令

连接电源

! 警告

  • Do not attempt to remove power plug(s) before turning OFF the Start-Stop switch (ST), 单元电路断路器(年代), 以及外部电源.
  • Make sure the power plugs are clean and dry before connecting to the power receptacle.

连接380/460 VAC电源

  • Make sure the Start-Stop switch (ST), located on the control panel, is in “0” position (Off).
  • 确认断路器CB-1, 位于控制箱中, is in “0” position (Off).
  • Plug the 460 VAC (yellow) cable into a de-energized 380/460 VAC, 三相电源, 并激活电源.
  • 将断路器CB-1置于“I”位置(On).
  • 关闭并固定控制箱门.

连接190/230 VAC电源

To allow unit operation on nominal 230-volt power, an autotransformer is required. 自耦变压器配有230 VAC电缆和接受标准460 VAC电源插头的插座. The 230-volt cable is black in color while the 460-volt cable is yellow. The transformer may also be equipped with a circuit breaker (CB-2). The transformer is a step-up transformer that provides 380/460 VAC, 三相, 50/60 Hz power to the unit when the 230 VAC power cable is connected to a 190/230 VAC, 三相电源.

过程

  • Make sure the Start-Stop switch (ST), located on the control panel, is in “0” position (Off).
  • 确认断路器CB-1, 位于控制箱中, 和CB-2, 位于变压器上, 都在“0”位置(关闭).
  • Plugin and lock the 460 VAC power plug at the receptacle on the transformer.
  • Plug the 230 VAC (black) cable into a de-energized 190/230 VAC, 三相电源, 并激活电源.
  • Set circuit breakers CB-1 和CB-2 to “I” position (On).
  • 关闭并固定控制箱门.

为 questions and concerns please contact our 米乐m6app官网下载服务 Center Refrigerated Group 1-.


米乐m6app官网下载服务backtop

In order to meet the requirements of our customer’s shipping temperature-sensitive cargo, 美森已经建立了一个全国性的销售和米乐m6app官网下载服务团队,以满足米乐m6app官网下载运输冷藏集装箱的需求. 米乐m6的国家冷藏货物销售团队可以为大陆和岛屿的米乐m6app官网下载提供支持. 销售或米乐m6app官网下载支持,请致电 1 - 800 - 9 -马特森


附加信息:你.C. Davis Postharvest 技术, Research and Information Centerbacktop

The following reference is provided for the benefit of our shippers and consignees. 美森公司尚未独立确认该信息,对该数据的任何错误或遗漏不承担任何责任. 美森将遵守发货人关于冷藏货物温度设置的指示,即使它与本文件所提供的信息不同,美森将不承担因遵照发货人的指示而造成的损失或损坏.

U.C. Davis Postharvest 技术, Research and Information Center